8
9
INSTALLATION REQUIREMENTS
Min.
Max.
30
"/ 36
"
Fig. 1
30"
24"
WARNING
ALL ELECTRICAL CONNECTIONS MUST BE IN ACCORDANCE WITH LOCAL
CODES, ORDINANCES, OR NATIONAL ELECTRICAL CODE.
IF YOU ARE
UNFAMILIAR WITH METHODS OF INSTALLING ELECTRICAL WIRING, SECURE
THE SERVICES OF A QUALIFIED ELECTRICIAN
.
Suf
fi
cient air is needed for proper combustion and exhausting of gases through the
chimney of fuel burning equipment to prevent back-drafting.
Follow the cooking equipment manufacturer's guideline and safety standards such as
those published by the National Fire Protection Association (NFPA), the American Society
for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and local code.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
hidden utilities. Ducted systems must always be vented outdoors.
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY:
1. This Range Hood can be vented through the top or back.
For ductless installation, install an Air Outlet Cap on the rear vent hole. If air will be
vented, install the damper attachment on the side that the air will vent through (top or
rear, shown in
Fig. 2
)
2. For optimal performance the Range Hood must be installed 24” - 30” in height from the
cooktop. (Fig. 1)
3. Electrical Requirements: Rated Voltage and Frequency:) 110-120V~ 60Hz. Motor Input
Power:
90
W
PRE-INSTALLATION
Ducted Mode
Recircula�ng
Mode
Ducted Mode:
Turn
the
knob to this se�ng
for Ducted Installa�on.
Recircula�ng Mode: Turn
the
knob to this
se�ng for a Recirula�ng Installa�on.
•
Please read the instructions carefully.
Unpack the Range Hood and check that all
functions are working before installing.
•
Ensure that the voltage (V) and the frequency (Hz) indicated on the sticker match the
voltage and frequency at the installation site.
•
Check that the area behind the installation surface to be drilled is clear of any electrical
cables or pipes, etc.
•
The stainless steel surfaces of the Range Hood are very easily damaged during
installation if scratched or bumped by tools. Please take care to protect the surfaces
during installation.
•
Protect the cooktop surface below with plywood, or similar material, to prevent
damage occurring during installation.
•
The manufacturer shall not be held liable for failure to observe all safety regulations.
IMPORTANT
!
READ BEFORE INSTALLATION
!
You will need to set the Range Hood mode to either Ducted or Recirculating.
1. Remove Aluminum Filters
2.
Locate Knob Settings located under the Motor
(Fig.
3
)
3.
Rotate the lever to either Ducted or Recirculating mode.
4. If
recirculating mode
is chosen, install the vent cover on the rear vent hole.
If
ducted mode
is chosen, install the damper on the vent hole where the air will vent
through (top or rear), and install the vent cover on the other vent hole (shown on Fig.2
of the previous page).
Fig.
3
Venting mode
