14
15
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
INSTALLING THE EXHAUST DUCTING
Important:
1
.
Remove the packaging tape on the damper (located at the top of the unit) and make sure the flaps are
able to move freely.
2
.
Use HVAC foil tape to wrap all the duct joints for an airtight seal
Important:
•
To provide extra support and to reduce the vibration, the appliance must fix onto the concrete wall
Important:
Install ductwork, making connection in direction of airflow as illustrated.
Secure joints in ductwork with sheet metal screws.
Wrap all duct joints with HVAC foil tape for an airtight seal.
Install Damper
1.
Position the damper over the damper adapter and secure using the screws provided.
f
WALL
f
DAMPER
f
DAMPER ADAPTER
IMPORTANT:
•
Observe all governing codes and ordinances.
•
It is the customer’s responsibility to contact a qualified electrical installer.
•
If codes permit and a separate ground wire is used, it is recommended that a qualified electrician
determine that the ground path is adequate. A 120-Volt, 60 Hz, AC-only, fused electrical supply is
required on a separate 15-amp circuit, fused on both sides of the line.
•
DO NOT ground to a gas pipe.
•
Check with a qualified electrician if you are not sure that the range hood is properly grounded.
•
DO NOT have a fuse in the neutral or ground circuit.
IMPORTANT: Save this Installation Guide for electrical inspector’s use.
GROUNDING INSTRUCTIONS:
•
This appliance must be grounded. In the event of an electrical short-circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric current.
•
This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be
plugged into an outlet that is properly installed and grounded.
WARNING:
Improper grounding can result in a risk of electric shock.
•
Consult a qualified electrician if the grounding instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded. DO NOT use an extension cord. If the power
supply cord is too short, have a qualified electrician install an outlet near the appliance.
Connect to AC Outlet
•
Connect AC plug into a grounded AC outlet having 120V,
60Hz. Place the outlet at a maximum distance of
33-1/2” (851 mm) from where the cord exits on the hood.
•
SEE IMPORTANT INSTRUCTIONS BELOW
3-Pronged Plug
Ground Plug
3-Prong Receptacle
