10
11
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR
PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE ANY
PARTS FOR INSTALLING, CLEANING OR SERVICING.
For the most efficient and quiet operation:
•
It is recommended that the range hood be vented
vertically through the roof through at least 10” round metal/
aluminum vent work.
•
Use no more than three 90° elbows.
• Make sure there is a minimum of 24” of straight vent be-
tween the elbows if more than one elbow is used.
• The length of vent system and number of elbows should
be kept to a minimum to provide efficient performance.
•
The vent system must have a damper.You may remove
damper flaps from damper to increase air flow.
• Use silver tape or duct tape to seal all joints in the vent
system.
• Use caulking to seal exterior wall or roof opening
around the cap.
IMPORTANT:
•
System must vent to the outside (roof or side wall).
•
DO NOT vent system into an attic or other enclosed
area.
•
DO NOT use laundry-type wall caps.
• Use metal/aluminum vent only. A rigid metal/alu-
minum vent is recommended.
•
DO NOT use a plastic
vent.
•
Always keep the duct clean to ensure proper airflow.
•
Calculate
the
following
figures
before
installation:
1. Distance from the floor to the ceiling
2. Distance between the floor and the countertop/
stove
3. A
distance of 24” to 36” is recommended
between
stove top and the bottom of range hood.
30” minimum
is required for gas stove tops.
4. Height of hood and duct cover.
Height and Clearance
24” (610 mm) Min / 36” (914 mm) Max
CAUTION: HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR
PROTECTIVE GLOVES WHENEVER IT IS NECESSARY TO REMOVE
PARTS FOR INSTALLING, CLEANING OR SERVICING.
A 47.75" x 2" x 4" wooden support (sold separately) is
required to properly install this Range Hood.
Install Wood Support
1. Locate at least two vertical studs at the wood mounting location by tapping drywall or by using a stud finder.
2. Position the supplied wood support ” (
mm) below the cabinet and drill 1/8” (3.175 mm) pilot holes through
the support, drywall and into the studs.
3. Secure the wood support to two or more vertical studs with wood screws (not provided).
4. Use threaded drywall anchors when mounting the hood onto sheet rock. Mounting the hood into wall studs or
lumbars is highly recommended.
0.5”
(12.7mm)
Wood Support
