12
2. Installation instructions
The Cosidesign Line is supplied complete with pressure regulator (30 mbar) and gas hose. You only need to
purchase a gas bottle. These can be purchased at your local gas supplier.
1. Installing the Cosidesign Line
Carefully remove your Cosidesign Line from its packaging and select the location for your Cosidesign Line. The
location must meet the following conditions:
-
Make sure that the Cosidesign Line is placed on a paved (preferably stone) surface. The surface should
be completely flat and clean.
-
The Cosidesign Line should be placed at least two meters away from flammable materials and liquids.
-
After placing the frame on a stable surface, you can now place the table top onto the frame.
We
recommend doing this with two people, to avoid the top from breaking.
Then you can place the
burner into the recess in the table top. Then the burner is easier to position if the control knob is first
removed from the burner. Once the burner is put into the recess, place the control knob back on the
burner.
Before the Cosidesign Line
is ready to use you have to place an AAA battery for the piezo ignition. Please see ‘2.5
Replacing the battery for the piezo ignition.’
When the Cosidesign Line is installed properly, you can place the lava rocks and ceramic logs on the top. Every
Cosidesign Line is supplied with small and large lava rocks. Take the small lava rocks without grit and place these
gently on the model. Repeat the process with the big lava rocks and make sure the burner is covered with lava
rocks. Keep the space around the ignition unit free of lava rocks and ceramic logs (see image below).
After placing the lava rocks, unpack the ceramic logs. The Cosidesign Line is always supplied with three pieces. It
is recommended to place the ceramic logs as follows:
Keep the space around the ignition unit free of lava rocks. Make sure the fire ring and ignition unit are only
minimally covered by the logs. If the logs block the fire ring, dangerous situations may occur. The blockade of the
fire ring will affect the air flow of the ring and the flames will be different. This results in dangerous situations!
If you want to order more lava rocks or ceramic logs, this is possible at your purchase address.
Pay Attention:
When you are going to use the Cosidesign Line for the first time, make sure that the device is
turned at the highest setting for 15 minutes. In this way, the lava rocks are heated through and this ensures that
any bumps or air bubbles will disappear from the lava rocks. During the first time the Cosidesign Line is turned
on or when the lava rocks have been wet (after some rain), keep at least
two meters away
from the burner and
also ensure that
no flammable materials are placed
around or on the table within this
radius of two meters
.
Because the air bubbles are burned from the lava rocks, the rocks can jump up during the first time / when lava
rocks have been wet and possibly come out of the burner.
When you want to move or clean up the lava rocks and ceramic logs, always make sure that they have cooled
down completely.
The lava rocks and logs can scorch black in time. This has to do with soot formation which always occurs in devices
that show a yellow flame. This soot can be removed by blowing / vacuuming with an ash vacuum cleaner. The
soot may also be brushed off with a dry brush.
Ignition unit
