Cosatto HUG, Руководство пользователя

Страница: 8 / 95

15 - preparing the child car seat for group 2/3 use - 3
Lift the bottom part of the seat cover to gain access to the waist harness clips.
Push the waist harness clip ends through the slots in the child car seat (a), push the clips
through from under the seat (b) and then through the seat cover.
Push the crotch harness clip through the slot in the underside of the seat (c) and then
through the seat cover and seat liner.
The seat liners can now be removed from the child car seat (d).
16 - preparing the child car seat for group 2/3 use - 4
Pull the harness adjuster connector (a) until the end of the harness adjuster strap fits
under the harness adjuster flap (b).
The adjuster strap can be folded and retained at the bottom of the child car seat base
with the fabric fastener (c).
Close the seat and refit the seat opening shaft.
17 - installing the child car seat in ISOFIX Group 2/ 3 mode (15 to
36kg, approx. 4 to 12 years old) - 1
Before installation, remove the harness and seat liners from the child car seat and lock the
back of the seat with the seat opening shaft. See steps 12 to 15.
NOTE:
The seat liners, harness, chest pads, crotch pad & chest
pad locking bar should be stored away safely for future use. The
chest pad locking bar MUST NOT be used in group 2 & 3
installations.
Fit the child car seat to the vehicle seat (a) and fasten the tether strap (b). See steps 8 to 10.
Release the vehicle seat belt lock (c) under the headrest. Feed the vehicle seat belt into
the gap (d) under the vehicle seat belt slot until the vehicle seat belt is located in the
vehicle seat belt slot. Push the vehicle seat belt lock back (e).
18 - installing the child car seat in ISOFIX Group 2/ 3 mode (15 to
36kg, approx. 4 to 12 years old) - 2
Place your child in the child car seat and fasten the vehicle seat belt.
Pull the vehicle seat belt upwards to tension the belt (a).
The vehicle seat belt should be positioned between your childs shoulder and neck (b).
If the vehicle seat belt is in the correct position the lap belt should fit over the red tags
sewn into the cover on either side of the seat (c). The height of the vehicle seatbelt can
be adjusted by squeezing the lever at the back of the headrest and raising or lowering
the headrest to the correct position (d).
IMPORTANT: The position of the seat belt/lap strap buckle can
affect the stability of the child car seat. In an accident this could