Cosatto HUG Nitty Gritty, Руководство пользователя

Страница: 7 / 28

Note: The harness, chest pads, crotch pad & chest pad locking bar should be
stored away safely for future use. The chest pad locking bar MUST NOT be
used in group 2 & 3 installations.
Release the vehicle seat belt lock (a) under the headrest. Feed the vehicle seat belt into
the gap (b) under the vehicle seat belt slot until the vehicle seat belt is located in the
vehicle seat belt slot. Push the vehicle seat belt lock back (c).
14 - installing the child car seat 15 to 36kg (group 2 & 3 approx.
4 to 11 years old) - part 2
Place your child in the child car seat and fasten the vehicle seat belt.
Pull the vehicle seat belt upwards to tension the belt (a).
The vehicle seat belt should be positioned between your child’s shoulder and neck (b).
If the vehicle seat belt is in the correct position the lap belt should fit over the red tags
sewn into the cover on either side of the seat (c). The height of the vehicle seatbelt can
be adjusted by squeezing the lever at the back of the headrest and raising or lowering
the headrest to the correct position (d).
For the safety of the child please check:
•
The diagonal belt section runs through the seat belt guide located on the headrest
and the lap belt must pass over the red tags sewn into the seat cover.
•
The straps are tightened and not twisted.
•
The vehicle seat belt buckle is correctly located on the side of the car seat and is not
obstructed.
Always make sure that your vehicle seat belts are correctly tensioned to ensure
maximum protection for your child.
Anchorage Group 2 and 3
The shoulder belt must cling to the child’s shoulder and chest. The lap belt must pass
over the red tags sewn into the seat cover.
When anchoring the child car seat, make sure the vehicle seat belt is not
twisted, in addition, the vehicle seat belt must be appropriately tensioned and
placed around the child’s body to ensure that the child car seat is properly
anchored. Always make sure that your vehicle seat belts are correctly
tensioned to ensure maximum protection for your child.
15 - removing the covers for cleaning
Remove the harness and seat liners if fitted (See steps 9 & 10).
Headrest: Lift the headrest to the highest position (a). Starting on one side carefully pull
the cover off (b).
Release the belt lock under the headrest (c) and pull the elastic loop through the gap (d).
Release the elastic loop (e). Repeat this procedure on the other side of the headrest and
remove the headrest cover.