8
22 Front end cap
1
53 M4X10 Screw
2
23 Lock knob
1
54 Spring bolt
2
24 Handle foam
2
55
Lower Sensor wire
1
25 Screw M4X15
6
56
Bottle holder
1
26 Front roller axis
1
57
Water bottle
1
27 Front roller
1
58
Multi-tool
1
28 Rear roller axis
1
59
Allen Wrench
1
29 Rear roller
1
60
Small Flat Washers ф4
4
30 Left rail
1
61 Accessory holder
1
31 Transport wheel
2
62
Incline Pin
2
63
Safety End Caps
2
ASSEMBLY INSTRUCTIONS
Place all the parts on the floor, and follow the assembly instructions below:
Step 1: Install the Flywheel Cover
Locate Flywheel Cover, 2x Flywheel Screws and 2x Small Flat
Washers.
Attach the Flywheel cover (10) to the Treadmill Platform
(1) with 2x Flywheel Screws (40) and Small Flat Washers
(60).
Note: The Screws and washers may be located in their
attachment holes on the Treadmill Platform. If so,
unscrew them before placing the Flywheel cover and use
them to secure the cover.
Step 2: Install the Base Support
Locate Base Support, Left and Right Handlebar Supports, and 4x
Medium Bolts.
Attach the Base support (6) to the Left support bar and
Right support bar (2,3) with four Medium Bolts (43) and
4 Washers (if supplied)
NOTE: DO NOT FULLY TIGHTEN THESE BOLTS UNTIL
AFTER
ATTACHING THE HANDLEBAR IN STEP 4.
NOTE: For your convenience, your Manual Treadmill comes
partially assembled. Most of the parts on this page and the
previous Overview page are
already installed,
so they will not be
found in the Hardware Pack which came with your Treadmill.
The parts needed to assemble your Treadmill are shown in the
list above shaded and in italics.
Содержание 5250MT
Страница 1: ...V1511 ...
Страница 7: ...6 OVERVIEW DRAWING ...