5.
Connect 22-pin plug from installation harness (See
Fig. 2
) to mating
connector on Module (See
Fig. 4
)
Fig. 4
6.
Connect (Tap) red wire from install harness to an ACC (Accessory or
switched) supply power source in vehicle.
1997-03 C5 Models
: locate 3-pin plug under passenger toe board
near BCM (covered with black duct tape) See
Fig. 3
--- tap yellow wire
OR if missing; use alternate accessory positions in fuse box.
Fig. 3
Note: The aforementioned 3-pin plug may not be present in all vehicles
Alternately
we suggest fuse:
#22, or 11
on interior fuse box. (See
Fig. 5
)
located under passenger toe board.
Please test circuit with voltmeter of
test light for proper operation prior to final install.
To aid the install we include a
in
Fig. 4
Fig. 4
Crimp accessory wire to add-a-fuse circuit and insert blade to fuse box (e.g.
fuse #22 etc.) If fuse position is occupied, remove fuse from fuse box and
insert to vacant slot on add-a-fuse circuit. Ensure proper crimp otherwise
module will not power up upon turning ignition/car to “ON” position.
Fig. 5
C5 interior fuse box (
yours may be different
)
Noteworthy
: If streaming is interrupted when an accessory is turned on
(e.g. headlights, wipers, defroster, A/C etc.), please find an alternate
source for accessory wire or seek help from a professional.
Module is not
faulty, but circuit to which it is connected is being drown down by
aforementioned accessory. If after installation no Bluetooth device
appears on phone, look through peephole on the bottom of the module
