NL
DE
EN
89
CUSTOMER MANUAL M400 DRIVE SYSTEM
Starting password:
Enter into “Start PassWord” interface and select “ON”. Briefly press (<0.5S) , and then it show input password in
the interface. This moment, briefly press (<0.5S)
or to switch numbers “0-9”, and then briefly press (<0.5S)
to confirm input number. After input, it show input password again in the interface. Repeat the above step to input
password again. If the password is same with the previous time, the system will prompt it is successful to set password,
otherwise it need to repeat the first step to input the new password and then re-confirm.
After setting the passwrod, the interface exit back automatically to original interface within two seconds. Briefly press
for two times (interval time is less than 0.5S) to exit back to main interface or select “BACK”
→
“EXIT” to exit back to
main interface.
Reset password:
After setting the password, the interface “Password” will add option “Reset Password”. Briefly press (<0.5S)
or to
select “Reset Password”, and then briefly press (<0.5S) . This time it prompt input current password in the interface.
If inputing worng password for ten tiems, the display will turn off automatically. When inputing right password, it prompt
input new passwrod in the interface. The following step is same with starting password. After changing the password, it
will exit automatically back to the original interface within two seconds.
Briefly press for two times (interval time is less than 0.5S) to exit back to the main interface or select “BACK”
→
“EXIT” to exit back to main interface.
