User’s Manual: SW-10200
14
Learning.
Click
Update
to save your changes. A table at the bottom of the main pane displays a summary of each port’s
configuration. The display shows the following information:
Current Status: Displays current port status.
Setting Status: Displays current status.
4.2. Port Mirroring
Configure port Mirroring on this page. This function monitors network traffic that forwards a copy of each
incoming or outgoing packet from one port of a network switch to another port where the packet can be studied. It
enables the manager to keep close track of switch performance and alter it if necessary.
Figure 14 - Configure port mirroring
The parameters for this setting are:
Destination (mirroring) port: For monitoring RX only, TX only or both RX and TX traffic from the source port.
Mirroring ports can be connected to LAN analyzer or Netxray.
Monitored Packets: Expand the drop-down menu to select between RX, TX or both RX and TX.
Source Port: Select ports to monitor. All monitored port traffic will be copied to the mirroring (destination)
port. Select multiple source ports by ticking the check boxes beneath the port number label to be monitored.
Click
Update
to save your changes
4.3. Bandwidth Control
Configure the allowed bandwidth on this page. The TX rate and Rx rate is given in a number ranging from
1
to
255
. This number should be multiplied by the selected bandwidth resolution to get the actual bandwidth.
Figure 15 - Set allowed bandwidth
A bandwidth usage summary is seen below.
