3
11. Lift the printbed support located at the back of the printer to release the lower foam
insert. Pull the foam insert from the front of the printer to remove as shown below.
12. Take the surface probe out of the electrical supply box and place it inside the device.
13. Refer to the Corning Matribot Bioprinter Instruction Manual (CLS-AN-641DOC) or the
Corning Matribot Bioprinter Introduction videos for start up instructions and support.
NOTE:
Please do not add/delete files to the SD card provided in the package.
10. Remove the middle inner foam insert as shown.
14. Keep all of the original packaging materials such as foams, plastic envelopes, return shipping label, and boxes in a safe place. You will
need them for repacking the instrument after completion of the demo.
