STANDARD RECOMMENDED PROCEDURE 009-221 | ISSUE 8 | AUgUST 2015 | PAgE 4 OF 10
6. Install Connector Panels or Modules
The ECL-C4U housing will accommodate up to
twelve connector panels or modules. They are
secured to the front of the housing with plastic
push-pull plunger fasteners. Secure the panels or
modules to the housing as shown in Figure 5.
7. Install Cable
7.1 Removing Doors
The front and rear doors may be removed to ease
installation. To remove rear door, slide it to the left
to release the hinges. To remove the front door,
lift the lever arm on the left side of the trough and
slide the door to the left (Figure 6). Reverse these
procedures to replace the doors.
7.2 Preparing Cable
WARNING:
Never look directly into the end of a fiber that may be carrying laser light.
Laser light can be invisible and can damage your eyes. Viewing it directly does not cause pain.
The iris of the eye will not close involuntarily as when viewing a bright light. Consequently,
serious damage to the retina of the eye is possible. Should accidental eye exposure to laser
light be suspected, arrange for an eye examination immediately.
WARNING:
DO NOT use magnifiers in the presence of laser radiation. Diffused laser light
can cause eye damage if focused with optical instruments. Should accidental eye exposure to
laser light be suspected, arrange for an eye examination immediately.
CAUTION:
Cleaved or broken glass fibers are very sharp and can pierce the skin easily. Do
not let these pieces of fiber stick to your clothing or drop in the work area where they can
cause injury later. Use tweezers to pick up cleaved or broken pieces of glass fibers and place
them on a loop of tape kept for that purpose alone.
Good housekeeping is very important.
Plunger
Plunger
Housing
Expanded
Fingers
KPA-2193
• Pull both plungers out
all the way.
• Position the two nylon
fasteners into the
mounting holes
• Press the plungers on
the fasteners.
To remove, pull the
plunger out.
Figure 5
Door Stop
KPA-2194
Figure 6
