Cornelius IDC 2XX Скачать руководство пользователя страница 6

IDC Operator’s Manual

© 2005-2010, IMI Cornelius Inc.

- 3 -

Publication Number: 621057403OPR

START-UP AND OPERATING INSTRUCTIONS

I

CE

 D

RINK

 D

ISPENSER

The ice drink dispenser shall be installed by qualified personnel following instruction given in the Installation manual 
part number 621057403INS. Fill the hopper with ice. Dispense several large cups of ice (approximately 20 to 30 
seconds total dispensing time) to allow ice to fill the cold plate cabinet. Add ice to the hopper as necessary to refill, 
then replace the lid. Allow 10 to 15 minutes for the cold plate to cool down. Repeat this procedure whenever the 
dispenser has run out of ice. Start up the beverage system and adjust faucets to the proper brix. Contact your local 
syrup distributor for complete information on the beverage system.

The ice drink dispenser is designed to operate in ambient temperatures ranging from 65 to 95

o

 F. Do not allow the 

unit to be stored or operated in conditions below 32

o

 F. This could cause damage to the unit.

CAUTION:

!

Dispenser cannot be used with crushed or flaked ice. Use of bagged ice which has frozen into large chunks can 
void warranty. The dispenser agitator is not designed to be an ice crusher. Use of large chunks of ice which “jam 
up” inside the hopper will cause failure if the agitator  motor and damage to the hopper. If bagged ice is used, it 
must be carefully and completely broken into small, cube-sized pieces and left to “temper” or warm up for a 
minimum of 20 minutes in room temperature before loading into the dispenser hopper

In normal operation, pushing the ice dispenser mechanism will cause ice to flow from the ice chute. Ice flow will 
continue until the dispenser mechanism is released. Dispensing of any faucet will provide beverage of the 
appropriate flavor.

!

WARNING:

Use caution to avoid spilling ice when filling dispenser. Clean up immediately any spilled ice from filling or operating 
the unit. To prevent contamination of ice, the lid must be installed on the unit at all times.

 Failure to clean up spills 

could result in serious injury or death

If the dispenser fails to dispense ice or beverage, refer to the troubleshooting section in the Installation Manual part 
number 621057403INS.

NOTE:  The dispenser is not designed for a wash-down environment and MUST NOT be placed in an area 
where a water jet could be used.

NOTE:  This appliance is not intended for use by personnel (including children) with reduced physical, 
sensory or mental capabilities or lack of experience and knowledge, unless given supervision or 
instruction concerning use of the appliance by a person responsible for safety.

Содержание IDC 2XX













Отзывы: