Cormach MOTO MEC, Руководство по эксплуатации и обслуживанию

Страница: 25 / 36

Use and maintenance manual – 10/2016 Rev. 3 Page 19
15.2 Wheel Type
The machine allows choosing one of three different Wheel Types, as listed in table T15.3.
Table T15.3: Wheel types available
Wheel type Vehicle Notes
MOTO
Motorcycles Default at switching on
QUAD
Quad
Each of the above programs sets specific values to measure wheel sizes and calculate imbalances. The special features of each
program are listed in the following paragraphs. To select a specific Wheel Type, press the [P6] key repeatedly [P6] until the
corresponding LED lights up, as shown in table T15.3.
15.2.1 MOTO Wheel type
The selection of MOTO wheel type allows the balancing for the motorbike wheels.
These wheels must be fit on the shaft by using a specific motorcycle wheel adaptor. Since the motorcycle adaptor keeps farer the
wheel from the machine, it is necessary to install an appropriate extension for the distance gauge (Figure F15.1.1).
The MOTO wheel type is selected by default at switching on. See table T15.3.
When MOTO wheel type is active, ALU1 Program Type is selected automatically. The weight position to be applied on rim section, it
is the Program Type ALU1 as showed in figure F15.2.
When the wheel type MOTO is activated, it is possible to display the dynamic or static imbalance, by pressing keys [P10] if
the wheel width entered is less than 114 mm (or 4.5 inches) the static imbalance is always displayed.
Figure F15.1.1: Fitting the extension for Distance/Diameter sensor to measure motorbike wheels
Every time the flange for motorbikes is taken down (for example, to balance wheels for vehicles) and then put back in, it is always
necessary to line up the “CAL” markings on the flange and flange for motorbikes. If this is not observed, balancing precision may be
compromised.
15.2.2 QUAD Wheel type
The selection of MOTO wheel type allows the balancing for the QUAD wheels.
To select the QUAD, press the QUAD [P6] key until the QUAD LED of the LED Wheel Type group lights up. See table T15.3.
For QUAD wheel type are available all programs listed in table T15.1.
The positions of the weights along the section of the rim are the same as those shown in Figure F15.2.
When the wheel type QUAD is activated, automatically, it is selected on the STD Program Type.
Extension for
sensor