Cormach MOTO MEC, Руководство по эксплуатации и обслуживанию

Страница: 20 / 36

Use and maintenance manual – 10/2016 Rev. 3 Page 14
13.2 STANDARD, SERVICE, STAND-BY operating modes
The machine features three operating modes:
• STANDARD mode. This mode is enabled after the machine is turned on and it is possible to perform the wheels balancing;
•
SERVICE mode. In this mode various utility programs are available for setting parameters (such as grams or ounces) or
checking the machine operations (such calibration);
•
STAND-BY mode. After 5 minutes of inactivity, the machine will automatically go into STANDBY mode to reduce power
consumption. The STAND-BY green LED on the control panel flashes when the machine is in this operating mode. All
acquired data and settings are held in STAND-BY mode. In the SERVICE mode is not possible to switch to STAND-BY mode.
To exit from STAND-BY mode choose by any of the following means:

Press any key (with the exception of [P7] );

Rotate manually the motorcycle flange so that the wheel will turn counterclockwise (Figure
13.4).
Figure 13.4: Action on motorcycle flange
Note: The machine will exit STAND-BY mode also by pressing the [P8] ALU key.
14. MACHINE CALIBRATION
To function properly, the machine must be calibrated. Calibration allows storing the mechanical and electrical parameters specific to
each machine so as to provide the best balancing results.
14.1 When to carry out machine calibration
Table T14.1 lists the cases in which machine calibration should be carried out. Calibration must be carried out whenever one or more
of the conditions listed are active.
Table T14.1: Conditions for carrying out machine calibration
Condition Status Who must perform it
When the machine is installed at the final user's site Mandatory Technical Service
When the electronic circuit board is replaced Mandatory Technical Service
When a mechanical part linked to the pick-up signal
(pick-up, pick-up compression springs, suspension
unit + shaft) is replaced Mandatory Technical Service
When the pick-up compression spring adjustment is
modified Mandatory Technical Service
When the encoder disc is replaced Mandatory Technical Service
When the machine does not provide the best
balancing results Recommended Final user and/or Technical Service
When there are large, constant variations in the
environmental humidity and temperature conditions
(for example seasonal changes) Recommended Final user and/or Technical Service