Corghi Artiglio Master Code, Руководство пользователя

Страница: 70 / 136

70 Artiglio Master Code User Manual
If necessary:
6. Continue inflating up to the maximum value of
3.5 bar to position the tyre correctly on the rim.
Avoid distractions during this operation, and con-
tinually check tyre pressure on the air pressure
gauge (1, Fig. 48f) to prevent excessive inflation.
Inflating tubeless tyres requires a higher air flow-
rate to allow the beads to bypass the rim HUMPS
- see types of rim profiles for mounting without a
camera in Fig. 49.
7. From the position of the centring ridges check
that the beads are properly positioned on the
rim; otherwise, deflate the tyre, break the beads
as described in the relevant section, lubricate
and turn the tyre on the rim. Repeat the mounting
operation described previously and check again.
8. Replace the internal mechanism of the valve.
9. Bring the pressure to the operating value by
pressing the Inflation push-button (2, Fig. 48f).
10. Fit the cap to the valve.
5.7.c. sPECIAl PROCEDURE
If, during inflation, the tyre does not seat on the rim because of the excessive gap between
the tyre/rim, it is possible to use an air-pressure airblast through the jaws on the TI acces-
sory (available on request).
Verify that both upper and lower tyre beads and the rim bead seat have been properly
lubricated with an approved mounting paste.
1. locking the rim (Fig. 50).
2. Remove the valve stem core if not already done (Fig. 50a).
3. Connect the inflation hose to the valve stem (Fig. 50b).
4. Pull up on the tyre lightly to reduce the gap between the upper bead and the rim (Fig. 50c).
5. Step down completely on the air inflation pedal and at the same time press the 2 but-
tons on the accessory to release a high-pressure air blast through the four jets to assist in
seating the beads of the tyre (Fig. 50d).
1
48f
2
“HUMP” (H)
“double HUMP” (H2)
49
50
50a 50b