Corecess R1-SW24L2B, Руководство пользователя

Страница: 269 / 300

Configuring STP/RSTP
13-11
Enabling or Disabling STP on a Port
If you enable STP on a VLAN, the change does not affects all ports belong to the VLAN.
Therefore you should enable STP on all Ethernet ports within the VLAN.
To enable STP on a port, perform this task in Privileged mode:
Table 13-5 Enabling STP on a port
Command Task
configure terminal
1. Enter global configuration mode.
port <port-type>
<slot>/ <port> stp
2. Enable STP on a specific Ethernet port.
y
<port-type>
: The type of Ethernet port to enable STP on.
- fastethernet
: Fast Ethernet port
- gigabitethernet
:
Gigabit Ethernet port
y
<slot>/<port>
: The slot number and port number of the
Ethernet port.
end
3. Return to privileged mode.
show stp port <port-type>
<slot>/<port>
4. Verify the STP configuration
.
y
<port-type>
: The type of Ethernet port
- fastethernet
:
Fast Ethernet port
- gigabitethernet
:
Gigabit Ethernet port
y
<slot>/<port>
: The slot number and port number of the
Ethernet port.
The following example enables STP on the port 1/1 and 2/1:
(config)#
port gigabitethernet 1/1 stp
(config)# port fastethernet 2/1 stp
(config)# end
# show stp port fastethernet 2/1
Link State: up
Protocol Operation: enabled
Pathcost Encoding: 32bit
Port Number(logical): 65
Port Priority: 0x08
.
.