Page 40
3.
Use a #2 phillips screwdriver to secure the
console front to the back shroud using eight (8)
pieces of the #8-18 x 3/4” pan head screw.
Note:
For
8-TR
with a
19”
screen only,
follow the directions for 8-TR Only on page
41.
Fig. 52
4.
Use a #2 phillips screwdriver to remove the screw
securing the hotbar cap into the hotbar, then
remove the cap.
5.
Install the Gen 2 audio insert, then secure with
the screw removed above.
Fig. 53
6.
If connecting to the network physically (preferred),
plug the ethernet cable into port B on the back of
the motor compartment.
7.
After powering the unit for the first time, the
computer will boot up and the Select Device
screen will appear in the display.
8.
Perform the “INITIAL SETUP” on page 6 to
complete installation.
PORT A
PORT B
Fig. 54
