5
MP6600 Series
Installation Instructions
Multi-Point Lock
FM526 03/20
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
Copyright © 2017, 2019, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
c
Instructions for MP6600 Series Multi-Point Lock
Important:
Check template 4740 to prep door for
function holes, size, and location.
1. Verify strike location according to template.
2. Clean out door pocket and door edge of
any debris.
3. Make sure the handing of the lock (latch and
locking piece) match the handing of the door.
4. Slide lock into the door and hold.
5. Slide outside lever and rose assembly (or lever
and escutcheon assembly) through the door;
lock body and hold.
Note:
Keep door open while installing lock.
If installing lever onto only one side of the
door, see separate instruction sheet.
6. Assemble keyed cylinder first through narrow
end of spring and then wider opening of collar
(or escutcheon).
7. Assemble onto door by threading into lock
until cylinder face is flush with collar edge.
Pulling key slightly out of cylinder will help
when threading cylinder inward.
Note:
Corbin Russwin logo must be horizontal and
on upper portion of cylinder face.
8. Tighten cylinder clamp screw with #2 Phillips
screwdriver.
9. Secure lock in door with two (2) #12 x 1-1/4"
wood screws or #12-24 x 1/2" machine
screws.
Do NOT tighten completely at this
time .
10. Slide spindle into lockbody hub.
11. Slide adapter and plate assembly over spindle
and secure with two (2) #8-32 screws.
Outside of Door
RH Door Shown
1
2
3
Figure 6
4
6
8
7
5
Figure 7
Outside
of Door
