5
ML2000 Series Mortise Lock
Installation Instructions
Used with VN Escutcheon Trim and V Series Indicators
FM521 11/21
Copyright © 2019, 2020, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
4
Rehanding Indicator (if required)
Verify hand and bevel of door. (Figure 7)
LH
Left Hand
Hinges Left
Open Inward
RH
Right Hand
Hinges Right
Open Inward
LHRB
Left Hand
Reverse Bevel
Hinges Left
Open Outward
RHRB
Right Hand
Reverse Bevel
Hinges Right
Open Outward
Figure 7
Note:
Stand outside of locked door when determining door hand.
Next, verify inside and/or outside indicators are handed correctly, using Spindle Cam Position chart.
(Figure 8) If they are handed correctly, skip to
Step 5a Prepare Door
. If they are not handed correctly:
1. Remove indicator back plate by pulling out from top slot, then remove spindle cam from assembly.
(Figure 9)
2. Position spindle cam in correct direction for door hand. (Figure 8)
Important:
For thumbturn indicators, make sure thumbturn is positioned in the 12 o’clock direction
as shown. (Figure 10)
3. Slide spindle cam post into correct slot of display slide. (Figure 9)
4. Re-seat back plate into original position.
5. Return indicator to the
v
acant/unlocked position for installation.
Door Hand:
RH/RHRB
Door Hand:
LH/LHRB
Spindle Cam Position
Inside Indicator
Outside Indicator
Outside Indicator
Inside Indicator
Figure 8
Spindle Cam
Back
Plate
Plate slot
for removal
Display Slide
Slot
Figure 9
Thumbturn
position
Figure 10
Scan this QR code for
the Corbin Russwin
Indicator Handing
Charts
