4
ML2000 Series Mortise Lock
Installation Instructions
Used with VN Escutcheon Trim and V Series Indicators
FM521 11/21
Copyright © 2019, 2020, 2021, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
3
Mortise Lock Handing
1. Move red locking screw to side of lock body
being locked.
2. Push in latch. Depress catch plate with
screwdriver. (Figure 2)
3. Pull latch out of lock body and turn latch
over. (Figure 3)
4. Push in latch while holding screwdriver behind
latch tail. (Figure 5)
Note:
Ensure that latch is pushed in until catch plate is no longer
depressed. (Figure 4)
5. Rotate lock front to match bevel of door, as shown. (Figure 6)
Figure 4
Figure 5
MAKE SURE CATCH PLATE IS
EVEN WITH TOP SURFACE
GOOD
BAD
WARNING: LOCK-IN CAN
OCCUR IF LATCH IS NOT
PROPERLY INSTALLED
Figure 6
Catch Plate
Figure 2
LOCK HANDING IS
CRITICAL TO ENSURE LOCK
FUNCTIONS PROPERLY
RED Locking Screw
Figure 3
