COP-USA NVR2832PD, Руководство пользователя

Страница: 13 / 66

NVR User Manual
8
Operation processes with remote controller to control multi-NVR
The default device ID of the NVR is 0. It’s not necessary to reset the device ID when a remote
is to be used to control a single NVR. However when controlling multiple NVRs with multiple
remote controllers, you would need to configure the device ID, please refer to below steps:
Activate remote controller to control the NVR: Turn the IR sensor of the remote controller
towards the IR receiver on the front panel, press the number key 8 twice on the remote, input
device ID of the NVR to be controlled (Range from: 0-65535; the default device ID is 0) and
press ENTER to confirm.
You can check the device ID of a NVR from System Setup
 Basic  Device ID. You can also
set multiple NVRs with the same device ID however this can cause interference if the NVRs
are kept close to each other.
2.5 Control with Mouse
2.5.1 Connect Mouse
It supports USB mouse through the ports on the rear panel.
If mouse is not detected or doesn't work, check below steps:
1. Make sure the mouse is plugged in the USB mouse port.
2. Try with a good known mouse.
2.5.2 Use Mouse
During live:
Double-click on any camera window to see the full screen. Double-click again to return to the
previous screen.
Right click to reveal the control menu on the screen. Right click again to hide the menu.
In Configuration:
Click to enter a particular option. Right click to cancel the option or to return to the previous
menu.
In order to input a value in a particular screen, move cursor to the input box and click. An
input window will appear as Fig 2-3. It supports digits, alphabets and symbols input. Click
Shift button to input capital letters and symbols; click Shift button again to return.
It supports mouse drag. Take motion detection area setup for example: Click customized, hold
down the left button and drag to set motion detection area.