![background image](http://html1.mh-extra.com/html/coopers/9487/9487_instructions-manual_2665302011.webp)
WARNING!
Make sure that the engine has stopped and is cool before performing and service
to the machine. Contact with the moving blade or hot muffler may result in a
serious injury.
AIR FILTER
If the air filter becomes clogged it will reduce the performance of the engine.
Check and clean the filter element. If the element is broken or clogged replace
with a new one. The air filter should be checked after every 25 hours of use and
cleaned if necessary. Always clean the air filter with either compressed air or by
tapping it, do not use water or any liquid detergents to clean the filter.
FUEL FILTER
When the engine runs short of fuel supply, check the fuel cap and the fuel filter
for a potential blockage.
SPARK PLUG
Starting failure and miss-firing are often caused by a soiled spark plug. Clean the
spark plug and check that the plug gap is 0.65mm. Check the spark plug for dirt
and grime after 10 hours or operation and if necessary clean it with a copper
wire brush. Thereafter a regular service after 50 hours of operation should be
carried out.
For a replacement plug, use the correct type as specified in the technical data
sheet in these instructions.
Please note:
Using a spark plug other than a L7T or
L7TC plug may result in the engine failing to operate
properly or in the engine becoming overheated and
potentially damaged.
To install the spark plug first turn the plug until it is
finger tight, then tighten it a quarter turn with a
socket wrench.
CLEANING
Keep all safety devices, air vents and the motor free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow it with compressed air
at a low pressure.
It is recommended that you clean the device immediately each time you have
finished using it.
Clean the equipment regularly with a damp cloth. Ensure no water can seep into
the device.
STORAGE
Oil the blade to prevent rust.
Empty the fuel tank and secure the cap on the fuel tank.
Remove the spark plug and pour a small amount of oil into the cylinder.
Store the hedge trimmer in a dry place, preferably not in direct contact with the
floor and away from heat sources.
STORAGE AND TRANSPORTATION
Aged fuel is one of major causes of engine starting failure. Before storing the
unit, empty the fuel tank and run the engine until it uses all the fuel left in the
fuel line and the carburetor. Store the unit indoors taking necessary measures for
rust prevention and safety.
When transporting the unit from location to location, it is recommended that all
the fuel is emptied. Danger from outside influences could affect the safety of the
unit,as these cannot be controlled if on the move eg. flammable fuel, danger
from stray cigarettes etc. Always transport with the blades covered and secure
the item to prevent accidental fuel spillage.
PACKAGING DISPOSAL:
• Dispose of the packaging at your local recycling centre.
• Dispose of paper and carton separately from plastic bags at your local recycling
centre.
• Dispose of the item at the end of its lifespan at your local authorised
household waste recycling centre.
11