10
CLEANING & MAINTENANCE:
• Keep all safety devices, air vents and the motor housing free of dirt and dust as
far as possible Wipe the equipment with a clean cloth or blow it with
compressed air at low pressure.
• It is recommend that you clean the device immediately each time you have
finished using it.
• Clean the equipment regularly with a moist cloth and some soft soap. Do not
use cleaning agents or solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the device
System Components Procedure
Before Use
Every 25 hours
Every 50 hours
Every 100 hours
Note
after
after
after
ENGINE
Fuel leaks,
Wipe out
fuel spillage
Fuel tank, air filter,
Inspect / clean
Replace if necessary
fuel filter
Idle adjusting
Adjust idling speed
Replace carburettor
screw
if necessary
Spark plug
Clean and readjust
GAP: 0.65mm
plug gap
replace if necessary
Cylinder fins,
Clean
intake air
cooling vent
TRIMMER
Throttle lever,
Check operation
ignition switch
Cutting parts
Replace if
something is wrong
Gear case
Grease
Screws, nuts,
Tighten / Replace
bolts
Debris guard
Attach
4
4 4
4
4
4
4
4
4
4
4
Cleaning & maintenance
Or as necessary