2
COOPER LIGHTING SOLUTIONS
IB519099EN
Installation instructions
Installation Instructions – Commercial LED Wraparound
INSTALLATION
1.
Turn off the power at the main fuse/breaker box.
Carefully open carton, remove fixture from carton.
2. Remove lens from luminaire by starting at one end
of the fixture and pressing in the center of the lens.
While pressing down on the lens, slide lens to fixture
end (Figure 1). There is a tab that the lens must slide
underneath to allow it to be removed (Figure 2).
Remove by squeezing the sides of the lens, while
pulling up to release it from the grooves in the housing
(Figure 3).
4. For surface mounting, use the provided mounting
holes on each end of the fixture housing (Figure 5).
Appropriate hardware should be used (supplied by
others).
Figure 1.
Figure 2.
Figure 3.
Figure 4.
Figure 5.
3. To remove the driver enclosure press inward on both
sides of enclosure to release tabs from housing.
Repeat for all mounting tabs (Figure 4). The driver
enclosure is tethered to the housing.
Press Down in Center of Lens
Push & Slide Lens Under Tab
Slide Lens To End
Holes for Y-Toggle (NLW Models Only)
Hole and Slot For
V-Hanger (All Models)
Surface
Mounting
Hole
Holes for Y-Toggle
(WLW Models Only)
Tabs
Tabs
