Page 13
KEY-KP01
To Disable/Enable the Status Fault LED
Action
Keypad Display
1. Enter Local Programming mode (see page 11)
MENU
ABCD
Y
2. Press
n
repeatedly until the display shows:
MENU
STATUS FLT LED
Y
3. Press
>
repeatedly to select one of the fol-
lowing:
Status Fault LED ON (
Y
).
MENU
STATUS FLT LED
Y
Status Fault LED OFF (
X
).
The red Fault LED under the navigation key
is disabled, and will not glow for any fault
reports.
MENU
STATUS FLT LED
X
4. Leave local programming mode and save your
changes (see below).
To Leave Local Programming Mode and Save Changes
EITHER:
Press
Y
OR
Close the keypad tamper.
The keypad saves the changes you have made in its local memory.
You can now remove 12VDC power, if required, or leave Installer Menu on the
control unit.
To Leave Local Programming Mode and Discard Changes
Press
X
. The keypad ignores any changes you have made.
External Prox Reader LED
The KEY-EP has a built in LED that can glow for 10s to indicate that the system
has set. This LED mimics the action of the LED under the “A” on the keypad as
follows:
In a part setting system the LED glows for 10s when the system enters Full
Set.
In an i-on30EX and i-on40 partitioned system the LED glows for 10s when
Partition 1 enters Full Set.
Note: The jumpers in the KEY-KP01 do not control the function of the LED in
the KEY-EP.
