Cooper Wheelock SAFEPATH SPB-160, Инструкция по установке, испытаниям, эксплуатации и техническому обслуживанию

Страница: 56 / 86

Chapter 4: Installation
Series SPB Audio Boosters Manual, Revision A
4-34
4.9 Installing AC Power and Batteries
NOTE: Power-limited and non-power limited wiring must be separated.
WARNING: Two different sources of power may be connected to
this unit (SPB-80/4 and SPB-160); for the SPB-320, each module uses
two different sources of power. Disconnect both sources of power
before servicing. Failure to disconnect both power sources before
servicing could result in serious injury or death to you and/or others.
CAUTION: Observe correct polarity requirements on all connections. Failure to
do so may damage the equipment.
CAUTION: Always apply AC voltage before applying batteries voltage. Failure to
do so may cause damage to the Series SPB Audio Booster panel.
4.9.1 Installing AC Power
NOTE: Power limited and non-power limited wiring must be separated by a minimum of ¼”.
1. For the SPB-80/4 and SPB-160, refer to Figure 4-20 (for the SPB-320, refer to Figure
4-21) and connect the line and neutral 120VAC input wiring to the L (Line) and N
(Neutral) terminals on the power supply module (SPBPS).
2. Connect the ground input wiring to the grounding terminal block on the right side of the
chassis.
4.9.2 Installing Batteries
NOTE: Batteries are not supplied with this panel and must be purchased separately.
4.9.2.A Installing Batteries on the SPB-80/4 and SPB-160
Connect the supplied red battery wire to the (+) terminal and the supplied black battery wire to
the (–) terminal of TB2 (BATTERY) connection.