Cooper Wheelock SAFEPATH SPB-160, Инструкция по установке, испытаниям, эксплуатации и техническому обслуживанию

Страница: 28 / 86

Chapter 4: Installation
Series SPB Audio Boosters Manual, Revision A
4-6
4.2.2 Mounting the Audio Booster
1. Mount the panel and optional expansion modules in the desired locations as described in
more detail in section 4.5.
2. Mount any additional wiring boxes or junction boxes needed to interconnect field wiring.
3. Connect conduit fittings or bushings as needed through the knockouts provided on the top
and bottom of the panel.
4.2.3 Installing Field Wiring Connections
NOTE: The terminal blocks on the Series SPB Audio Booster are removable. To remove a
terminal block, pull the block straight up from the circuit board, as shown in the figure below.
Attach wires to the desired connections, and then plug the terminal block back on the board,
being careful to match the pins.
Figure 4-3 Removable Terminal Block
1. Install field wiring in conduit when required, following the most current National
Electrical Code (NFPA-70) and local codes for the type of system being installed.
2. Make all necessary connections at any additional wiring or junction boxes.
3. Separate power limited and non-power limited wires. The wiring shown in Figure 4-8 is
recommended.