Cooper Tools Cleco mPro400GC, Быстрая настройка

Страница: 3 / 20

Page 3
PL12-1004EN
03/31/2010
Cleco
®
mPro400
GC
Controller
About this quick set-up guide:
This quick set-up guide is the -- original quick set-up guide -- and is intended for all persons who configure
settings on the mPro400GC controller.
The quick set-up guide does the following:
•
It provides important instructions for safe and effective operation.
• It describes the function and operation of the mPro400GC controller.
• It points out options.
The following documents provide additional information for the operation and service of the mPro400GC
controller.
PL12-1000EN Parts Manual
PL12-1001EN Programming Manual
Workplace safety symbols:
This warning sign identifies all references to safe work practices in this quick set-up guide, alerting
of hazards to life and health of personnel. Observe these notes and proceed with special care in
the situations described. Pass all safety instructions on to other operators. In addition to the safety
instructions in this quick set-up guide, all local safety and accident prevention rules must be
observed.
This warning sign identifies all references to potential electrical shock, alerting of hazards to life
and health of personnel. Observe these notes and proceed with special care in the situations
described. Pass all safety instructions on to other operators. In addition to the safety instructions
in this quick set-up guide, all local safety and accident prevention rules must be observed.
This “Note” symbol identifies the portions of this quick set-up guide requiring special attention to
ensure that guidelines, rules, hints and correct procedures are observed and to prevent damage
to or destruction of the machine and/or parts.
Disclaimer:
Cooper Tools reserves the right to modify, supplement or improve this document or the product without
prior notice. This document may not be reproduced in whole or in part in any way, shape or form, or copied
to another natural or machine-readable language or to a data carrier, whether electronic, mechanical,
optical or otherwise, without the express permission of Cooper Tools.