DC Inverter U-match Series Duct Type Unit
20
3.2.3 Connection Pipe Installation
3.2.3.1 Installation Notice and Requirement on Connection Pipe
NOTICE
①
.
Indoor unit adopts special joints that can
’
t be disassembled. The installation
method is the same as the unit with ordinary joints. However, because the
joints can
’
t be removed, if the connection is not good and causes leakage, the
joints need to be cut and welded again for replacement.
②
.
The removal-proof screw nut must be connected to the indoor unit.
Installation method: Connect the connection pipes first to the indoor unit and
then to the outdoor unit. When bending a connection pipe, be careful not to
damage the pipe. Do not over-tighten the screw nut, otherwise leakage will
occur. Besides, the outside of connection pipe should be added with a layer of
insulating cotton to protect it from mechanical damage during installation,
maintenance and transportation.
