10
Before cleaning the oven, wait for it to cool down.
It is best to clean the bottom of the oven after every use and not allow the food or spots of oil to remain and
become permanent stains.
Wash surfaces in warm soapy water. For stubborn marks on glass surfaces, a mild cream cleaner can be
used. Dry parts with a soft cloth.
For the interior surfaces in the oven use normal oven cleaners but always read the manufacturer’s
instructions on how to use them.
Do not use caustic paste, abrasive wire, powders or hard instruments to clean any part of the appliance.
Cleaning the oven
Cleaning the glass doors
Ensure the oven doors are cool before cleaning. Removal of a
door makes it easier to clean the door, the door surround and
the seals.
To remove a door proceed as follows:
1.
Open the door fully.
2.
Raise one hinge clip and rotate it towards you as far as the
stop (Figure 10). Repeat the procedure with the second
hinge clip on the other side of the door.
3.
Raise the door gently until it comes to rest against the hinge
clips.
4.
Grip the edges of the door and lift the door clear of the
catches in the hinge openings.
5.
When cleaning the door, take care not to move the clips from their position.
6.
Once cleaning is complete, lift the door and slide the hinges into the hinge openings.
7.
Engage the slots on the hinges with the catches in the hinge openings.
8.
Check that the weight of the door is fully supported on the hinges.
9.
Lower the door and raise the hinge clips, then return them away from you and back to their starting
positions.
10. Check that the seal is in place then close the door. Make sure that the inner face of the door meets and
shuts against the seal all around.
HINGE CLIP
STOP
CATCH
SLOT
HINGE
OPENING
Figure 10 - removing the oven door
Changing the lamps
Wait for the oven to cool.
Unscrew and remove the diffuser. Unscrew the lamp from
the lampholder. Replace lamp and diffuser (Figure 11).
The replacement lamp must be of the same type, voltage
and wattage (25W SES 300°C).
LAMP
LAMPHOLDER
DIFFUSER
Figure 11 - changing the lamp
Mains lead replacement
Do not attempt to repair or replace the mains connecting cable yourself, consult a qualified
electrician.
