16-Port USB3.0 Metal Hub with Surge Protection and DIN RAIL Mounting Kit
3
1.
Use static electricity discharge precautions.
Remove possible static discharge potential from any objects that
the hub may come in contact with before installation. This can be
accomplished by touching a bare metal chassis rail after you
have turned off the power.
2.
Apply DC power (range from +12V to 24V) to the 2-pin Terminal
Block Connector.
The hub was self-powered by this connector.
3.
Connecting USB Host cables:
The host cable could be either a
standard A-to-B USB3.0 cable or an optional A-to-B USB3.0
screw-lock cable. Please connect the type-A end connector of
the cable to your PC’s host USB3.0 port, then insert the type-B end
connector to this hub. Since the USB hub is plug-and-play, you
don’t have to turn off your host computer when installing the hub.
This hub provides 2 upstream type-B connectors, if you only need
one, connect either of them and leave the other unconnected.
However, please note the rocker switch should be set at correct
position in this case.
4.
Connect the USB devices to the downstream ports of this hub.
5.
Mount your hub on the wall or DIN RAIL if required.
3. Hardware Installation
DIN RAIL Clips
Wall
mounting
holes
Wall
mounting
holes
Mounted on the DIN RAIL
