Cool Machines 1500 Series, Руководство пользователя

Страница: 15 / 49

Rev. 12/8/2017 Page 15
4) Blower motor running hot.
A. Clean or replace filter(s) located on lower base unit, below slide gate. Check intake of blowers for debris/
insulation. Blow out blower motor and surrounding area with compressed air.
B. Check blowing hose for blockage. A restriction in the output hose will cause the blowers to run hotter than
normal.
C. Check blower(s) for proper operation. (i.e. bearings, armature, excessive arcing by worn brushes.
D. Blowers have a limited life due to brush commutator wear. Blower may need replaced.
5) Excessive arcing of brushes on blower motor. (‘hissing’ or ‘scratchy’ noise)
A. Blow out brush assembly area with compressed air to remove accumulation of dirt and debris.
B. Re-seat brushes (motor repair shop). If damage to commutator is severe, replace blower.
6) Auger/Airlock motor does not run; but Blower is running.
A. Check reset breaker inside main panel box. Manual Reset on auger/airlock motor is tripped. Disconnect power
to machine. Wait until motor cools (approx. 15 minutes), Turn base unit on side and access from under machine
and press reset button on motor.
B. Check procedure for cold temperature starting above.
B. Check for defective, broken, or loose wiring connections inside main control panel.
C. Visually inspect and replace motor relay/starter inside main panel box if needed.
7) Auger/Airlock motor running improperly or hot.
A. Disconnect power. Check augers/shredders, and airlock for debris.
B. Low voltage. Check voltmeter on main panel box when machine is running. Try another electrical source. Use
proper size input cords.
C. Check bearings, chain and sprockets for problems or drive system misalignment.
D. Remove chains from motor reducer assembly. Run motor/reducer under power and check Amperage.
E. Check voltage, hertz, phase (1 phase), and direction of rotation.
F. Replace auger/airlock motor or gear motor...
8) Airlock Feeder not turning.
A. Check sprockets for missing key. Replace with
3/16” key.
B. Chain broken or slipped off sprocket. Repair or replace.