Cool Machines 1500 Series, Руководство пользователя

Страница: 13 / 49

Rev. 12/8/2017 Page 13
Maintenance:
Daily:
Empty fiber from machine daily.
Clean blower filter(s). Brush off exterior when not running.
(NOTE:
Blower filter covers w/3” output tubes are available from factory)
Weekly:
Clean blower filter (remove and blow out with compressed air) and vacuum fiber and debris from
under machine area. (Excessive fiber build-up around motors will cause heat and prevent normal
cooling, resulting in reduced motor life.)
See illustration below: arrows to chain and idler.
Monthly:
Check airlock seals and plates for damage. (See troubleshooting: checking airlock seals)
Visually inspect and/or re-tighten all chains and sprockets.
Quarterly: (3 months)
Grease all bearings (6 total) with NLGI #2 Grease. (do not overfill, or grease seals will leak).
Blower Filters / Keep Clean
Feed Gate
Adjustment
Pin
Check chain tension
Grease bearings
Idler Sprocket Chain Tensioner
Clean under base unit
Idler Sprocket
Chain Tensioner