SETTING THE SENSOR
Remember, your pool water level must be correct to
continue:
Step 6
: Very slowly lower the sensor into the PVC sensor
pipe until the water flow stops and the ON &
SENSE lights flash every two seconds.
Step 7
: Once the water turns off, the SENSOR is now at
the correct required position in the pipe. Fasten
the sensor lead to the pipe with a zip tie to
prevent the sensor from moving up or down in
the pipe.
Step 8
As an indicator for the position of the sensor in
the pipe, mark the sensor lead with a
pen/marker to indicate how far the sensor has
been lowered into the pipe.
Step 9
If the pipe is in an area where debris can get into
the pipe, it is recommended to put an end cap
on the pipe but make sure it is not air tight.
THE SENSOR IS NOW SET AT THE CORRECT LEVEL AND IS
TO REMAIN AT THIS LEVEL TO ENSURE THAT THE YOUR
POOL IS ALWAYS FILLED PROPERLY.
IMPORTANT INSTALLATION STEPS:
PLEASE FOLLOW STEPS 10 – 12 TO ADJUST THE WATER
WITCH FROM TEST MODE TO OPERATING MODE.
7
