Initial Set Up
Step by step Guide
Once the Water Witch has been mounted properly,
TESTING OF THE WATER WITCH is required. To ensure
that the sensor and solenoid are working properly,
please complete the following steps:
Step 1
: Ensure the pool is filled to the operating water
level required.
Step 2
: Connect the sensor and solenoid plugs to the
control box ensuring that the plugs are
connected as indicated on the label on the
control box (
sensor left
; solenoid right).
Step 3
: Turn power and water supplies on. The ON light
will automatically come on and begin to flash.
Depending on what position the sensor is in, will
determine if the sense light is on and flashing or
the fill light is on.
Step 4
: Holding the sensor upside down, check that the
ON & SENSE lights are flashing approximately
every two seconds.
Step 5
: Turn the sensor the right way up and the ON
light will continue to flash and the FILL light will
come on. This will turn the water on to fill the
pool.
IF THE WATER DOES COME ON, YOU HAVE CORRECTLY
INSTALLED THE WATER WITCH SYSTEM
.
PLEASE FOLLOW STEPS 6 TO 9 TO
SET THE SENSOR
.
6
