32
7 Safety and ESD Precautions
1) Always connect the box to specified power source: 100 to 240 V AC,
50/60 Hz. DO NOT use any power supply other than the one supplied
with the HD-Connect LE™, as this voids the warranty.
2) Do not operate the unit in an unprotected outdoor installation or in wet
areas. Do not expose this product to rain or snow.
3) Keep the operating temperature between 5º C and 40º C (40º F and
104º F). Avoid conditions which would cause moisture condensation
on the outside cover.
4) There are no user serviceable components inside the box. Only a
qualified technician should perform servicing of the unit. Opening the
box may void the warranty.
5) Do not pour water or any other fluid over the box. Avoid the use of
sharp objects near the box as they may scratch the anodized
aluminum case or damage the DIP switch and board.
6) Clean only with water with a damp cloth.
7) CAUTION: Electrostatic Discharge (ESD) can damage components in
this product. Although HD-Connect LE™ has countermeasures to this
hazard installed inside, it is always best to avoid damage by using
extra caution when adjusting the DIP switch settings.
8) Do not touch exposed connector pins and do not insert any metal
objects in the connectors.
9) Because it is powered, take extra caution when plugging in the 1394
port 6-pin connector. DO NOT cock the connection or you risk
destroying the port. Blown firewire ports are not covered under the
warranty.
10) Ensure that all connections made to the box (including at the “other
end of the cable”) are made in ESD safe environments.
11) Always transport and store the box in the static protected bag included
with the HD-Connect LE™
12) Do not use mechanical pencils to adjust the DIP switches, as this
deposits lead stains on the switch that are impossible to remove.
HD-Connect LE™ Guide and User’s Manual.
