6.
-
CONVECTAIR
recommends that your heater be installed by a qualified
electrician and in accordance with national and local codes.
- This heater must be connected to a 240 volt (60 cycles) circuit.
Disconnect the power supply before making wiring connections
to prevent electrical shock and equipement damage. If you are using
a programmer system, make sur to cut the power off All electrical
heating circuits in the home
- To prevent short circuits and electrical shocks turn the power off
at the main panel before attempting the installation or making
any repairs.
- If the power cable is damaged it must be replaced by the manufacturer,
an approved service depot or a technician with similar qualifications to
avoid any danger.
3
electrical connection
RESPECT WIRE COLOR WIRING
- Turn off the power of this unit and all the devices connected to the pilot wire before
opening.
- The grounding of the pilot wire (purple wire) can cause serious damage to
- internal circuits.
- Never connect the pilot wire (purple wire) to power cord.
- Always connect the ground wire (green wire) with copper wire.
- The purple wire of which the end is sealed, is not to be used for electrical connection.
- This wire will be used if the device is connected to the CONveCTAIR central
programming system.
- fix the unit on the wall bracket before turning the power back on.
!
