11.
6
overheat control
This heater is equipped with separate overheat controls for the convection element and
for the fan-forced heat. In case of a malfunction of the unit (blocked air output or intake,
for example the heater will stop heating automatically. After correcting the malfunction
the heater can be reset.
To reset the heater :
- for the convection element: Check that the front panel, top and bottom of the heater
are free of obstruction. Once the obstruction is removed and the heater cools down, the
overheat control will reset automatically.
- for the fan-forced heat: Turn the back switch of the heater to sTANDbY. Check that
the lower back inlet and the lower front outlet are free of obstruction. wait 5 minutes and
turn the heater switch back on.
7
Maintenance
To keep your
CONVECTAIR
unit clean, regular maintenance is suggested. To remove
dust, use a soft cloth. To remove a stain, use a damp cloth.
For a better performance and maximum efficiency, it is suggested that dust and lint be
regularly removed from the protective grill situated in front of your ADAgIO.
NEVER USE ABRASIVE OR ACETONE-BASED PRODUCTS TO CLEAN YOUR
HEATER AS THIS MAY DETERIORATE THE EPOXY FINISH.
ANY REPAIR ON YOUR CONVECTAIR HEATER SHOULD ONLY BE DONE BY A
QUALIFIED TECHNICIAN, AND ONLY AFTER HEATER HAS BEEN DISCONNECTED.
Recommendations and advice
Your
CONVECTAIR
heater will become hot when in use. Caution is advised when young children are
present.
Do not insert small objects in the heater : this could cause an electrical short circuit, fire or damage to the
inner components.
Any use or modifications not approved by
CONVECTAIR
may cause electrical short circuits, fire or injuries
to the users.
In certain cases, it is possible for yellowing of the surface to occur over time.
This is not due to a manufacturing defect.This is caused by surrounding air, which may contain smoke or
dust, being heated and circulated through the heater.
Prevention : it is suggested that surfaces be frequently cleaned especially with units installed
in locations where cigarette smoke is present or in the kitchen. Never use this heater during
construction work or other activities that generate a lot of dust.
The first time your CONVECTAIR heats, a light smoke could be released. This is normal and should
disappear after about 2 to 3 minutes.
Содержание adagio 7640
Страница 2: ...2...
