OPERATION cont.
Air Conditioner Features
Step 7:
Timer Function
Step 8: Setting the timer
Your air conditioner has a SLEEP
mode, activated by pressing the button on
the control panel or remote control. SLEEP
mode will change the fan speed to low and
increase the set temperature by 1°C each
hour for 2 hours. No further change will
occur after the 2nd hour.
Sleep Mode can only be used during
Cooling mode, and will be cancelled if the
MODE is changed, the cooler goes into
standby or the
‘
Water Full
’
alert occurs.
The air conditioner is fitted with a timer
function. This can be set up to 24 hours in
advance. To use this function, the cooler
must be plugged in and ready to operate.
With the air conditioner ON, press the
TIMER button on the remote control or
control panel. The control panel display will
flash and show the time setting. Press the
TIMER button to increase the time in 1 hour
increments from 1 - 24 hrs. After 3 seconds
the display will revert to the SET
temperature.
When the air conditioner is OFF (but still
plugged in), repeat the above to set the ON
time. The air conditioner will start up with
the last settings used.
When the air conditioner is working,
only the TIMER OFF can be set. When the
air conditioner is off, only the TIMER ON
can be set.
Note!
How to cancel the timer
00
To cancel the timer, set the time to
using the control panel or remote control.
The TIMER indicator will stop glowing.
CP10-12CW1 Portable Refrigerated Air Conditioner
8
Draining the Air Conditioner
To drain the air conditioner, place it over a
drain point before unscrewing the cap and
removing the drain plug, as water will flow
out as soon as the plug is removed.
Remove the plug at the bottom rear of the
appliance and allow the tank to
completely drain (Fig 12B).
Note! Always replace the drain plug
immediately after draining.
Always disconnect the air conditioner from the electricity mains before cleaning or
draining.
To maximize the efficiency of the air conditioner, clean regularly.
Never operate the air conditioner without the filters.
Cleaning the housing
Cleaning the filters
Note!
Use a soft, damp cloth to wipe the body clean.
Never use aggressive chemicals, spirits, detergents, chemically treated cloths, or other
cleansing solutions. These substances could possibly damage the cabinet
Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt and then rinse
under running water (no hotter than 40°C).
Dry thoroughly before replacing.
Take care to replace the filters back into the slots in the cooler.
.
Remove the filters from the top and bottom air inlet vents as shown (Fig 12A).
End of season storage:
•
Drain any water from the unit.
•
Operate the unit in fan only mode for a few hours, to thoroughly dry the inside.
•
Clean or change the filters.
•
Replace in the original carton or cover for storage.
•
Unplug and carefully store the power cord and plug end.
MAINTENANCE
B
12 A
Remove all filters (4 total)
from the air conditioner
and clean every 2 weeks.
SEELEY INTERNATIONAL
–
OWNER
’
S MANUAL
9
