Controls 15-D0410, Инструкция по эксплуатации

Страница: 54 / 68

Manuale di Istruzione
Instruction Manual
27/10/2010 15-D0410-/Y -/Z Rev. 1 EN
50
4. Move the sieve plate clockwise until a resistance is felt to impede the rotation. This
resistance is produced by the cam which produces the vertical movement of the
plate, continue the movement until reaching the maximum height of the cam;
Fig. 5-6
5. Continue the rotation for approximately 180° until reaching the maximum height of
the second cam;
6. Read the displacement on the dial gauge: it should be 2mm ±0,3mm with respect to
the zero position;
7. If the displacement read on the dial gauge is out of these limits it will be necessary to
adjust the rods of the plate as follows:
a.
Reading less than that specified (vertical movement less than that required):
lower the plate;
b. Reading more than that specified (vertical movement more than the required):
raise the plate;