11
Option Settings
This thermostat has four OPTION settings that can be customized by the user.
The OPTION data will appear in the lower pane of the LCD screen.
It is recommended to set up the OPTION settings after you install the new thermostat
or before you start programming it.
While it is still possible to enter Option Settings any time to make changes, it may result in
a change or a reset of your set programs.
OPTION 1 - 12-Hour or 24 Hour Clock Format
1. Press and hold SET for three seconds to enter the Option Setting mode.
The first option is 12-hour or 24-hour clock format. (12:Hr will flash).
2. Press
▲
or
▼
to toggle between 12-hour or 24-hour format.
3. Press SET to proceed to OPTION 2 or wait for 15 seconds to confirm and exit Option Settings.
Note: 12-hour clock format is the default mode.
OPTION 2 - Heat Cycle Rate
1. Press SET again to advance to the second option. (Cr:1 will flash).
2. Press
▲
or
▼
to adjust setting. (See cycle rate supplementary information on page 12.)
Cr:0 = Full power, No Cycle (For fan-assisted baseboards and electric heating devices.)
Cr:1 = 20 Sec. Proportional Power (For non-fan-assisted baseboards and electric heating devices.)
Cr:2 = 240 Sec. Proportional Power (For fan-assisted heaters and radiant floor/ceiling heating devices.)
3. Press SET to proceed to OPTION 3 or wait for 15 seconds to confirm and exit Option Settings.
Setup
Option
