CONTROL SOLUTIONS CS Medical Systems CS6103, Инструкция для пациентов

Страница: 29 / 36

Patient Instruction Manual CS6103 Interferential Stimulator
Page 29 of 36 Control Solutions LLC
Mode Description
Stimulator (Stm) Provides a beat frequency as set on the display that lasts for 6
seconds followed by a ramp down to 0 amplitude for 6 seconds.
This phase is followed by a ramp back to the original amplitude
where the cycle is repeated. The treatment lasts for the
configured treatment time. After the auto timer timeout out, the
unit will turn off to conserve battery power.
Memory (Mem) The unit provides the therapy programmed into this memory
location.
Table 10 - Modes of Operation Descriptions
Additional Parameters
Table 11 lists the additional parameters and related information. These parameters
should only be set as directed by the physician or therapist.
Display Meaning Unit Value/Range Default
Frq Beat Frequency Hertz 1
– 150
†
SwT Sweep Time Seconds 1
– 63
†
OnT On Time Seconds 1
– 63 †
Tim Treatment Time Minutes 1
– 100 †
Save
Location to Save Treatment n/a Mem Mem
Table 11 - Additional Parameters
After Treatment Care
Follow the guidelines below to get the most out of your reusable electrodes and CS6103
Interferential Stimulator.
Reusable Electrode Care
To ensure the reusable electrodes are cared for properly:
1. After use grasp the corner of the electrode and gently remove it from the skin.
Do not pull on the electrode snap or wire connection.
2. Reapply the release liner to the adhesive side of the electrode.
3. Store the electrode in a resealable pouch or plastic bag.
To prolong the life span of the electrodes, remoisten them by applying a few drops of
water when they show signs of drying out or losing their adhesive. After repeated
usage, reusable electrodes begin to lose their adhesive and therefore deliver less
stimulation and shorten battery life. Replace reusable electrodes as needed.
†
The default for this parameter is dependent on the mode selected.