CONTROL SOLUTIONS CS Medical Systems CS6103, Инструкция для пациентов

Страница: 26 / 36

CS6103 Interferential Stimulator Patient Instruction Manual
Control Solutions LLC Page 26 of 36
Treatment Using Standard Built-In Modes
Follow the steps in Table 7 to select the correct treatment mode, amplitude and to begin
treatment.
Step Action
1
Turn on the CS6103 by pressing the button. After the initial "splash"
screen, the LCD will display:
2
Press

to select the Mod parameter. The selected parameter will blink.
3 Press either + or
–
to change to the correct
Mod
as prescribed.
4
If directed by the physician or therapist, press

to select
Frq
,
SwT
,
OnT
,
Tim , or Save parameter
– see
Additional Parameters on page 29. The
parameters will blink when selected.
5 Press + or
–
to change the parameter as prescribed.
6
Press

to select the Amp parameter. The selected parameter will blink.
7 Press + to increase the output intensity (amplitude) of the electrodes until
the level prescribed by your health care professional is reached.

The displayed numbers represent tenths of a volt e.g. 000 = 0V, 100 =
10.0V, 155 = 15.5V etc.

Once the treatment starts, if the stimulation is uncomfortable for any
reason, press
–
to reduce the intensity. This may reduce the
effectiveness of the muscle stimulation when using
Stm
mode. Please
discuss this situation with the treating physician or therapist.

If no stimulation is felt, please refer to Troubleshooting the CS6103
on page 33. Treatment will not begin until the
Amp
value is set greater
than zero.

As a safety precaution, the
Amp
parameter is reset to zero whenever the
Mode is changed.
8 Treatment automatically begins approximately 10 seconds after pressing
last keypad button.
9 If the stimulation is uncomfortable for any reason, press
–
to reduce the
intensity. This may reduce the effectiveness of the muscle stimulation.
Table 7 - Treatment Setup
When treatment begins the LCD will display the amplitude (
Amp
) and patient treatment
timer (
Time
). See Figure 6.
Figure 6 - Treatment Display
Amp Time
005 020
000
Std
Amp Mod The "Mod" of operation may display: Std,
36R, 36A, Cnt, Stm, or Mem.