If a “5” is pressed: (high or low set point is selectable with the DIP switch)
(the high / the low) temperature alarm setpoint is now xxxx degrees
To change (the high / the low) temperature alarm set point press zero
Otherwise to return to the main menu press one
If a “6” is pressed:
The security code is xxxx
To change the security code press zero
Otherwise to return to the main menu press one
If a “7” is pressed:
The battery is now ##.## volts
The battery (is in / is not in) an emergency condition
To return to the main menu press one otherwise hangup
If a “8” is pressed:
The power is (off / on) to return to the main menu press one otherwise hangup
If a “9” is pressed:
Greeting message is now [custom message] to change press zero
Otherwise to return to the main menu press one
The following data must be programmed into the Freeze Alarm:
A. TEMPERATURE ALARM SETPOINT – temperature at which an alarm call out will be initiated (rise or fall).
B. CALL OUT TELEPHONE NUMBERS – three telephone numbers to be called in succession during an alarm condition.
C. SECURITY/LOCATION CODE – three-digit code used to gain access to main menu or disable unit and can also be used
to identify location.
MENU DESCRIPTIONS
CALL OUT TELEPHONE NUMBERS:
Follow verbal prompts to enter call out telephone numbers. You may enter the
same number more than once, or enter the star (*) key to leave an entry blank
(no number). Pressing the pound (#) key will place a 5 second pause between
digits. Do not place pauses at end of telephone number(s).
CURRENT TEMPERATURE:
Reports the current temperature of the sensor.
TEMPERATURE ALARM SETPOINT:
The setpoint is the temperature at which the Freeze Alarm will initiate an alarm
call to your programmed telephone numbers. The setpoint will be used as either
a high or a low setpoint depending on the position of the DIP switch #7. The
setpoint is factory set to activate below –40°. Follow verbal prompts to change
the setpoint. The setpoint should be more than ten degrees above or below the
room temperature.
SECURITY CODE:
The security code is factory set at "999". Follow verbal prompts to change
security code. The security code can also be used as a location ID code.
BATTERY STATUS:
Low battery alarm will occur at 7 volts. Important: Battery should be replaced
annually, or when power drops to 7 volts or below. Unplug battery when unit
is not in service.
POWER STATUS:
Unit will report that the "power is off" in the event of a power failure.
RECORD A MESSAGE:
A custom greeting message may be recorded. The message can be up to 20
seconds long. When the recording is done, press the starkey (*). The greeting
message will be used as follows "Hello, this is [greeting message]"
