14
Installation considerations
The WA-700 should be installed in a dry, clean location near an AC power outlet and a
telephone wall jack, as shown in Figure 8.
Do not install or connect your WA-700 monitor to power or phone lines during a lightning
storm. Failure to observe this warning could result in an electrical shock.
Do not install the WA-700 in a confined space, such as a bookcase or in-cabinet, in direct
sunlight, or where it might get exposed to water. Failure to observe this caution could
result in poor performance or damage to the WA-700.
Use ONLY the AC power adapter sent with the WA-700. The use of other AC power
adapters could result in damage to the WA-700.
Do not install the WA-700 in high dust and debris areas. Failure to observe this caution
could result in damage to the WA-700.
Do not install the WA-700 in an area with chemical fumes or corrosive vapors. Failure to
observe this caution could result in damage to the WA-700.
WA-700 assembled
Figure 8 shows an example of an ideal setup of the WA-700 fully assembled. Place the WA-
700 on any flat surface, preferably a table top near an AC Power outlet and a phone jack as
shown in Figure 8. Once the WA-700 is fully assembled and operational
(power LED ON)
,
perform a phone test to ensure that the WA-700 can call the call-to phone number during an
alarm.
Figure 8: WA-700 Assembled
Warning
Caution
CA
NC
EL
TE
ST
P
R
O
G
0
9
8
6
5
4
1
2
3
7
Pro
g
ra
m
A
la
rm
P
ow
er
Power ON LED
