™
Supported Touch Screen Models
• C4-TSWMC7 – 7” In-Wall Touch Screen, Black or
White
Supported Adapter Kit Models
• C4-7IETOMTSAK, Black or White
General Description
This Control4® adapter kit provides an adapter plate
to accommodate the installation of a 7” In-Wall Touch
Screen. The kit is intended for an existing Mini Touch
Screen to be replaced by a 7” In-Wall Touch Screen.
Requirements
• Tools to modify the back box, such as a tape
measure, a pencil, a screwdriver, a small saw to
cut heavy plastic, a utility knife, or a handheld
rotary cutting tool.
• A 5/16” nut driver or socket wrench, if using the
metal wall box.
What’s in the Kit
• Adapter plate
• Two (2) screws for power box installation
• 7” In-Wall Touch Screen Adapter Kit for Mini
Touch Screen Installation Guide
(this document)
Specifications
Adapter Kit for a Plastic Back Box Model:
• Plastic back box (installed previously)
• Adapter plate
7” In-Wall Touch Screen-
Adapter Kit for Mini
Touch Screen
Installation Guide
Adapter Kit for a Metal Back Box Model:
• Metal back box (installed previously)
• Adapter plate
Prepare for Installation
Plastic Back Box Model
1
Remove the old Mini Touch Screen and leave the
back box in place in the wall.
2
Note the angle-shaped back box divider inside
the box (see below). You’ll need to cut a section
out of this back box divider. Using a heavy knife
or a handheld rotary cutting tool, measure and
mark 1 inch down from the front of the divider.
3
Cut vertically down so there’s a 1-inch cutout in
the back box divider. You’ll need this space for
the 7” In-Wall Touch Screen power box.
4
Remove the plastic piece you just cut out (see
photo next).
5
Go to the ‘Installation’ section next for more
instructions.
Metal Back Box Model:
1
Remove the old Mini Touch Screen and leave
the back box in place in the wall (see example
below).
2
Using a screwdriver, remove the screw that holds
the back box divider in place.
3
Remove the back box divider. You’ll need this
space to install the 7” In-Wall Touch Screen
power box. While you’re at it, also remove the
grounding screw from the back box. You’ll need
this screw to move the grounding wire to your
new adapter plate.
Back Box Divider Cutout
Back Box
Divider
