18
To connect a device to the Pluggable Terminal Block:
1.
Insert one of the wires required for your device into
the appropriate opening in the Pluggable Terminal
Block you reserved for that device (refer to Table 2-1
on page 14).
For example, if you were adding a motion sensor, you
would connect its wires to the following
Contact
openings: power input to
+12V
output signal to
SIG
,
and ground connector to
GND
. See the sections that
follow for instruction on connecting the various
protocols.
2.
Tighten the screw for that opening.
3.
Repeat Steps 1-2 for all wires required for your
device.
NOTE:
When you connect dry contact closure devices,
such as door switches, connect the switch b12V
(Power) and SIG (Signal).
Connect to the Contact Port
The Home Theater Controller provides one contact port
as a subset of the pluggable terminal block provided. See
the following figures to determine how to connect the
device to a contact port.
Figure 2-1.
Connect Contact Port for Voltage Source (i.e. Motion Sensor)
12V
SIG
GND
COM
NC
NO
RX
TX
GND
Provides
Signal
Input
Return
Path
power for
small
devices
