All you need to do is simultaneously press and hold the “Red Lock/Unlock”
bu�on on the remote controller and turn “ON” the remote controller (by
moving the power switch to the right). The remote controller will send out 2
beeping sounds and the indicator light ” ” will keep flashing (indica�ng
that the remote controller is now ready to pair; you can also change the
“Thro�le Mode” at this �me).
During this point (and before pairing with the drone), you are able to select
the control mode which best suits you. Please see pages 12 – 13
for thro�le control op�ons.
Re
mo
te C
o
ntr
oll
er Ba
�
ery Insta
ll
a
�o
n
Re
mo
te C
o
ntr
oll
er Si
g
na
l
C
o
nnec
�o
n
● Insert ba�eries with correct polarity.
● Do not mix old and new ba�eries.
● Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) ba�eries.
● Rechargeable ba�eries are to be removed from the drone before being
charged.
● Rechargeable ba�eries are only to be charged under adult supervision.
● Exhausted ba�eries are to be removed from the drone.
● The supply terminals are not to be short-circuited.
● In order to avoid ba�ery leakage causing damage to the remote controler,
please take out the ba�ery if not in use for a long �me.
ATTENTION:
● Any interrup�on during the pairing process will disrupt pairing.
● You must not turn on the drone prior to this step. Otherwise, you
will not be able to connect the drone and the remote successfully.
● This is the only �me you can change between Remote Controller
Thro�le Modes. If you wish to change modes a�er pairing, you must
turn off the drone and the remote and repeat this process again.
10 11
NOTE - Please make sure that the drone is turned off
Pic. 1
Pic. 2
Pic. 3
Step 1: Unfold the hand s�cks and open the ba�ery door (Pic. 1);
Step 2: Install 2*AA ba�eries into the ba�ery compartment according to
the given polarity (Pic. 2);
Step 3: Close the ba�ery compartment (Pic. 3).
