Continental Motors O-200-D, Инструкция по установке и эксплуатации

Страница: 12 / 112

1-2 O-200-D & X Series Engine Installation and Operation Manual
3 January 2017
Introduction
1-1.1. Advisories
This manual utilizes three types of advisories; defined as follows:
WARNING
A warning emphasizes information which, if disregarded, could
result in severe injury to personnel or equipment failure.
CAUTION: Emphasizes certain information or instructions, which if
disregarded, may result in damage to the engine or accessories.
NOTE: Provides special interest information, which may facilitate
performance of a procedure or operation of equipment.
Warnings and cautions precede the steps to which they apply; notes are placed in the
manner which provides the greatest clarity. Warnings, cautions, and notes do not impose
undue restrictions. Failure to heed advisories will likely result in the undesirable or unsafe
conditions the advisory was intended to prevent. Advisories are inserted to ensure
maximum safety, efficiency, and performance. Abuse, misuse, or neglect of equipment can
cause eventual engine malfunction or failure.
1-1.2. Compliance
The information in this manual must be incorporated into the applicable aircraft design
data and the Airplane Flight Manual/Pilot’s Operating Handbook (AFM/POH) by the
aircraft manufacturer.
Refer to the AFM/POH published by the aircraft manufacturer for operating instructions
and specifications relative to your aircraft. Prior to commencing engine installation,
consult the Continental Motors web site to verify the current status of the manual relating
to the intended procedure.
1-1.3. Using this Manual
Except for the engine installation drawings, illustrations in this manual are for reference
only, depicting the most prominent configuration in the engine series. Consult the
illustrated parts breakdown on the Continental Motors web site for your specific engine
model and each subsystem.
Exploded assembly illustrations accompany instructions throughout the manual. Parts in
illustrations (Figure 1-1) are identified with numerical callouts (indices). Corresponding
parts listings follow the illustrations for reference. The first time instructions refer to an
illustration, the figure number is identified in parentheses, followed by the callout. In
subsequent parts references, only the callout will be specified unless the referenced
illustration changes.